Ultimaker Cura slicer settings for RepRapPro Huxley

Here is how I configure Ultimaker Cura Slicer software for the RepRapPro Huxley 3D printer. The settings are for Cura 14.03 but will probably work for later versions also. The settings are for 1.75 mm PLA with 0.5 mm nozzle. When launching Cura a wizard will open.  I use these settings for my Huxley:

Step 1. RepaRap
Step 2. W=140,  D=140,  H=110, Nozzle = 0.5, Heated bed=yes, Bed center is (0,0,0) = no

Dowload my Cura profile from here.

In Cura load the file with: File -> Open profile...

I generate gcode files that i put on an SDCARD. I then use Pronterface to start the print.

Below are some screenshots of how is should look after loading the profile file.

Basic:

Advance:

End gcode. I have only changed the circled line: